BaTiO₃ is one of the ferroelectric materials with excellent dielectric properties such as high dielectric constant, low dielectric loss, and is widely used for the manufacturing of capacitors, piezoelectric converters, microsensors, and ferroelectric memories. Inkjet printing is a technology which uses digital and contactless methods which significantly improves flexibility associated with material and structural design, reducing manufacturing costs. Therefore, the top and bottom electrodes, BaTiO₃ ink, and photocurable resin were all printed by an inkjet to produce a BaTiO₃ capacitor. The properties of the printed thin film were analyzed. It was confirmed that the photocurable resin ink was well-infiltrated between the BaTiO₃ powder particles printed by inkjet. The dielectric properties of the capacitor such as dielectric constant which varies in accordance with frequency, polarization and tunability that changes with voltage, were measured.

In this paper, we analyzed the effects of the number of TIPS-pentacene droplets and also the substrate temperature on the performance of OTFTs As the number of the droplets increased, the mobility increased and reached the perk value and then reduced at all temperatures. The peak mobility was 0.14 ± 0.03 cm²/V sec at 3 droplets and 41℃, 0.19 ± 0.02 cm²/V.sec at 4 droplets and 46℃,and 0.35 ± 0.10 cm²/V sec at 7 droplets and 51℃. The reason of existence of peak mobility can be found in matching the evaporation of solvent with the velocity of crystal formation. When two parameters were properly matched, the mobility produced the highest.

We were analyzed the piezoelectric characteristic for electronics printing to inkjet printing system. These applications were possible use to Actuator, MEMS, FPCB, RFID, Solar cell and LCD color filter etc. Piezoelectric print head is firing from ink droplet control consideration ink viscosity properties. At this time, micro pattern for PCB metal printing was possible by droplet control of piezoelectric driving. These driving characteristics are variable voltage pulse waveform. We are used the piezoelectric analysis software of Finite Element Method (FEM), Piezoelectric design parameters are acquired from piezoelectric analysis, and measurement of piezoelectric. It designed for piezoelectric head to possible electric print pattern of inkjet printing system. For this validity we were established through in comparison with simulation and measurement. Designed piezoelectric specification obtained voltage 98V, firing frequency 10 kHz, resolution 360dpi, drop volume 20pl, nozzle number 256, and nozzle pitch 0.33 mm.