This paper reviews the energy yield enhancement characteristics of bifacial photovoltaic systems combined with solar tracking, focusing on their performance relative to conventional monofacial fixed-tilt configurations. The fundamental mechanisms of yield improvement are summarized, highlighting the largely additive contributions of solar tracking, which increases front-side irradiance, and bifacial modules, which utilize rear-side reflected and diffuse radiation. Reported results from previous studies indicate that bifacial systems with single-axis tracking typically achieve 25–35% higher annual energy yield compared with standard monofacial fixed-tilt systems, with variations depending on environmental and design conditions. Key design and environmental considerations influencing system performance are discussed to provide practical insights for the application of bifacial tracking systems in utilityscale photovoltaic installations.

The potential of replacing crosslinked polyethylene (XLPE) with an eco-friendly alternative, polypropylene (PP), as insulating material is investigated for overhead power distribution lines. Although XLPE exhibits excellent electrical and mechanical properties, the byproducts generated during crosslinking pose environmental challenges. PP is a viable alternative because of recyclability and absence of byproducts during crosslinking. This study evaluated alternating current (AC) breakdown strength, contact angle, and tracking resistance of two commercially available XLPE samples and three types of PP (PP1, PP2, PP3) with varying additive content. AC breakdown strength, analyzed using the Weibull distribution, facilitated relative comparison of insulation performance. PP2 exhibited scale parameters comparable to or exceeding those of XLPE. Contact angles exceeding 90° displayed hydrophobicity across all samples. To address pass/fail evaluation limitations, arcing images from tracking tests were analyzed using the box-counting method for fractal dimension analysis. Fractal dimensions increased with arcing extent, and complexity increased with test duration. Tracking resistance performance order was PP3, PP1, CC, PP2, OC which was attributed to enhanced heat dissipation properties of filler additives. The proposed quantitative method for comparing tracking resistance through fractal dimension analysis, explored the feasibility of using PP insulating materials in overhead power distribution lines.

In this study, an induction heating system using resonance is developed to remove remaining moisture and contaminations which could be generated during fabricating secondary batteries. This system is composed of power supply and induction coil. Power supply needs an oscillator, zero crossing detection, frequency tracking function, and induction coil needs a dummy coil to obtain a uniform temperature distribution. It is very important to obtain a uniform heating temperature distribution of battery cell case in the induction heating system before pouring electrolyte into battery cell. Experimental results show a temperature distribution deviation of below 1℃ in the external position of battery cell cases. As well, the temperature of battery cell itself shows distribution of 40℃±3℃.

An experimental study was conducted using the tracking wheel test (IEC 62217) method for evaluating the performance of insulator materials, in particular ethylene propylene diene monomer (EPDM) and silicone rubber. In addition, we studied the tracking characteristics resulting from applying the same method for the shape of the insulator housing, that is, the performance of regular and alternating sheds. The evaluation parameters were leakage current, surface characteristics, SEM, EDX, hydrophobicity, and temperature distribution; likewise, we applied the commercial frequency dry (and wet) flashover voltage test. We found that the regular shed had a greater leakage current than the alternating shed and that the recovery of the hydrophobicity in terms of rest time was greater than that of the EPDM in terms of leakage current. All of the regular-shed insulators of silicone rubber had tracking traces and choking on the sheath parting line, while the alternating shed showed only choking at the interface but no tracking traces. Therefore, it can be concluded that the commercial frequency wet flashover voltage of the silicone rubber with regular shed before and after the tracking wheel test is higher than that of the alternating shed.