For integrated complementary metal oxide semiconductor (CMOS) circuits, the lateral spread for two-dimensional (2-D) impurity distributions are very important for the analyzing the devices. The measured two-dimensional SEM data obtained using the chemical etching-method matched very well with the results of the Gauss model for boron implanted samples. But the profiles in boron implanted silicon were deviated from the Gauss model. The profiles in boron implanted silicon were shown a little bit steep profile in the deep region due to backscattering effect on the near surface from the bombardments of light boron ions. From the simulated 3-D data obtained using an analytical model, the 1-D and 2-D data were compared with the experimental data and could be verified the justification from the experimental data. The data of 3-D model were also shown good agreements with the experimental and the simulated data. It can be used in the 3-D chip design and the analysis of microelectro-mecanical system (MEMS) and special devices.
